Yukon/Denali 2WD V8-4.8L VIN V (2005)
Seat Belt Buckle: Service and Repair
No. 2 Rear (60/40 Split - 50/50 Split)
SEAT BELT BUCKLE REPLACEMENT - NO. 2 REAR SPLIT)
CAUTION: To avoid personal injury to the occupants of the vehicle, observe the following precautions:
-
More than one supplier's seat belts are used, therefore, install ONLY the seat belt components specified in the GM parts catalog.
-
To verify that the correct seat belt components were installed, insert the seat belt latch in the seat belt buckle. The latch must be fully
seated and be retained in the buckle until purposely released.
Removal Procedure
1. Remove the handle mounting screws (1).
2. Partially Remove the seat cushion cover by separating the cushion trim J-strips.
3. Remove the bolts attaching the buckle to the seat cushion frame.
4. Remove the buckle from the seat frame.
Installation Procedure
1. Install the buckle to the seat frame.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the buckle bolts.
Tighten the bolts to 53 N.m (39 lb ft).
