Yukon/Denali 2WD V8-4.8L VIN V (2005)
Seat Belt Buckle: Service and Repair
No. 2 Rear (Bench)
SEAT BELT BUCKLE REPLACEMENT - NO. 2 REAR
CAUTION: To avoid personal injury to the occupants of the vehicle, observe the following precautions:
-
More than one supplier's seat belts are used, therefore, install ONLY the seat belt components specified in the GM parts catalog.
-
To verify that the correct seat belt components were installed, insert the seat belt latch in the seat belt buckle. The latch must be fully
seated and be retained in the buckle until purposely released.
Removal Procedure
1. Remove the seat cushion cover.
2. Remove the bolt (1) from the buckle assembly.
3. Remove the buckles from the seat frame.
Installation Procedure
1. Install the buckles to the seat frame.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the bolt (1) to the buckle assembly
.
Tighten the bolt to 53 N.m (39 lb in).
3. Install the seat cushion cover.
