Yukon/Denali 2WD V8-4.8L VIN V (2005)
Seat Belt Retractor: Service and Repair
No. 1 Rear - 1
SEAT BELT RETRACTOR REPLACEMENT - NO. 1 REAR
CAUTION: To avoid personal injury to the occupants of the vehicle, observe the following precautions:
-
More than one supplier's seat belts are used, therefore, install ONLY the seat belt components specified in the GM parts catalog.
-
To verify that the correct seat belt components were installed, insert the seat belt latch in the seat belt buckle. The latch must be fully
seated and be retained in the buckle until purposely released.
Removal Procedure
1. Remove the door sill plate.
2. Remove the lower anchor bolt from bodyside panel.
3. Remove the third pillar trim panel.
4. Route the belt through trim panel.
5. Remove the bolt from the upper guide.
6. Remove the bolt from the retractor.
7. Remove the seatbelt anchor bolt cover.
8. Remove the floor anchor bolt.
9. Remove the assembly from the vehicle.
Installation Procedure
1. Install the assembly to vehicle.
2. Install the bolt to the retractor.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolt to 55 N.m (41 lb ft).
3. Install the bolt to the upper guide.
Tighten the bolt to 55 N.m (41 lb ft).
4. Route the belt through trim panel.
5. Install the third pillar trim panel.
6. Install the lower anchor bolt to bodyside panel.
Tighten the bolt to 55 N.m (41 lb ft).
