Yukon/Denali 2WD V8-4.8L VIN V (2005)
10. Remove the retractor from the seat.
Installation Procedure
1. Position the seat belt retractor onto the seat. Line up the tab on the retractor to the tab on the seat frame.
2. Install the upper anchor bolt.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolt to 53 N.m (39 lb ft).
3. Install the retractor tower cover.
4. Install the retractor tower cover retaining screw.
Tighten the screw to 2 N.m (18 lb in).
5. Install the retractor.
6. Install the retractor bolt.
Tighten the bolt to 53 N.m (39 lb ft).
7. Install the rear cardboard panel retainers.
8. Install the seat back cover and pad.
9. Move the seat to its original position
Right Front
SEAT BELT RETRACTOR REPLACEMENT - RIGHT FRONT
