Yukon/Denali 2WD V8-4.8L VIN V (2005)
2. Install the upper anchor bolt.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolt to 53 N.m (39 lb ft).
3. Install the retractor tower cover.
4. Install the retractor tower cover retaining screw.
Tighten the screw to 2 N.m (18 lb in).
5. Install the retractor.
6. Install the retractor bolt.
Tighten the bolt to 53 N.m (39 lb ft).
7. Install the rear cardboard panel retainers.
8. Install the seat back cover and pad.
9. Move the seat to its original position
No. 1 Rear - 1
SEAT BELT RETRACTOR REPLACEMENT - NO. 1 REAR
CAUTION: To avoid personal injury to the occupants of the vehicle, observe the following precautions:
-
More than one supplier's seat belts are used, therefore, install ONLY the seat belt components specified in the GM parts catalog.
-
To verify that the correct seat belt components were installed, insert the seat belt latch in the seat belt buckle. The latch must be fully
