Yukon/Denali 2WD V8-4.8L VIN V (2005)
11. Install the latch cover (1) to the seat.
Tighten the screw to 2 N.m (18 lb in).
12. In order to secure the seat back, manually rotate the center latch. Rotate the latch until the seat back clicks into position.
13. Install the seat to the vehicle.
No. 2 Rear (Bench)
SEAT BELT RETRACTOR REPLACEMENT - NO. 2 REAR
REMOVAL PROCEDURE
CAUTION: To avoid personal injury to the occupants of the vehicle, observe the following precautions:
-
More than one supplier's seat belts are used, therefore, install ONLY the seat belt components specified in the GM parts catalog.
-
To verify that the correct seat belt components were installed, insert the seat belt latch in the seat belt buckle. The latch must be fully
seated and be retained in the buckle until purposely released.
1. Remove the seat back cover and pad.
2. Remove the seat belt retractor bolt (1) from the seat frame.
3. Remove the retractor.
INSTALLATION PROCEDURE
1. Install the retractor.
NOTE: Refer to Fastener Notice in Service Precautions.
