Yukon/Denali 2WD V8-4.8L VIN V (2005)
Rear Wheel Steering Switch: Service and Repair
Rear Wheel Steering Mode Switch Replacement
Removal Procedure
1. Remove the dash trim bezel.
2. Grasp the rear wheel steering mode switch housing (2) and pull outward to remove the switch assembly.
3. Disconnect the electrical connector (3) from the rear wheel steering mode switch.
4. Remove the rear wheel steering mode switch assembly (1) from the vehicle.
Installation Procedure
1. Reconnect the rear wheel steering mode switch (3) electrical connectors.
2. Install the rear wheel steering mode switch (1) into the dash.
3. Reinstall the dash trim bezel.
