Yukon/Denali 2WD V8-4.8L VIN V (2005)
Steering Angle Sensor: Service and Repair
Steering Wheel Position Sensor Centering
Steering Wheel Position Sensor Centering
Removal Procedure
1. Verify the type of steering wheel position sensor.
Important: Identify the type of steering wheel position sensor from the illustrations shown BEFORE removing the sensor from the steering
column. Once you have identified the steering wheel position sensor, follow the instructions listed in the removal procedure.
2. From the technicians point of view, the FRONT of the sensor (1) connector will be on the right.
3. Remove the connector from the sensor.
Important: If reusing the existing sensor, you do not have to align the sensor before removal. Centering is not required when it is time to
reinstall.
4. Remove the sensor (1) from the adapter and bearing assembly.
5. To install the sensor, proceed to step 1 in the installation section.
6. From the technicians point of view, the FRONT of the sensor will have:
^
A foam ring (2)
^
A pin hole (1) for centering the pin. Note the location of the pin hole.
^
A flush rotor flange cuff (4)
7. Make an alignment mark on the flush rotor flange cuff (3).
Important: If reusing the existing sensor, you must make an alignment mark on the rotor flange cuff (3) before removing the sensor. Failure to do
so will cause misalignment when installing the sensor. A new sensor will be required if misaligned.
8. Remove the connector from the sensor.
9. Remove the sensor from the adapter and bearing assembly.
10. To install the sensor, proceed to step 5 in the installation procedure.
