Yukon/Denali 2WD V8-4.8L VIN V (2005)
1. Install the shock absorber. Insert the stem through the hole in the shock bracket on the frame.
2. Align the shock absorber with the mounting holes in the lower control arm, 15 Series.
3. Align the shock absorber with the mounting holes in the lower control arm, 25/35 Series.
4. Install the shock absorber bolt (2) to the lower control arm.
Notice: Refer to Fastener Notice in Cautions and Notices.
5. Install the shock absorber nut (3) to the bolt.
^
Tighten the nut to 80 Nm (59 ft. lbs.).
Important: The upper insulators are substantially larger that the lower insulators. The upper insulator (1) must be installed above the shock
mounting bracket on the frame. The plastic pilot ring (2) will assist the alignment of the isolators.
