Yukon/Denali 2WD V8-4.8L VIN V (2005)
4. Install the third and fourth clutch accumulator housing gasket (3).
5. Install the third clutch accumulator piston spring (1). This spring is the longer of the two springs.
6. Install the fourth clutch accumulator piston spring (4).
7. Install the third and fourth clutch accumulator housing assembly (5) onto the control valve body assembly (2).
8. Install the six accumulator housing bolts (6). Start the bolts finger tight and work towards the opposite end.
9. Notice: Refer to Fastener Notice in Service Precautions.
Tighten the accumulator housing bolts sequentially.
^
Tighten the bolts to 11 Nm (97 inch lbs.).
10. Remove the J 25025 .
11. Install the valve body.
