Yukon/Denali 2WD V8-4.8L VIN V (2005)
10. Install the transmission crossmember.
11. Install the transmission crossmember bolts/nuts.
^
Tighten the bolts/nuts to 95 Nm (70 ft. lbs.).
12. Install the transmission mount nut.
^
Tighten the nut to 50 Nm (37 ft. lbs.).
13. Remove the support from the transmission.
14. Lower the vehicle.
15. Install the transmission oil level indicator.
16. Fill the transmission to the proper level with DEXRON III transmission fluid.
Manual Shift Shaft Seal Replacement
Manual Shift Shaft Seal Replacement
^
Tools Required
-
J 43911 Selector Shaft Seal Remover
-
J 43909 Selector Shaft Seal Installer
Removal Procedure
1. Remove the Park/Neutral Position (PNP) switch.
2. Ensure that the jackscrew for J 43911 is backed off and will not interfere with installation of the removal tool. Slide the seal remover tool over the
selector shaft (2) with the threaded end of the tool towards the seal.
3. Rotate the removal tool so that the threads on the end of the tool engage the steel shell (1) of the seal. Use a wrench to ensure that the removal tool
is firmly attached to the seal shell.
4. Rotate the jackscrew in the clockwise direction to remove the seal from the bore. Discard the seal that was removed.
Installation Procedure
