Yukon/Denali 2WD V8-4.8L VIN V (2005)
11. Install the cable to the steering column bracket.
12. Ensure the tangs fully seat (snap) into the steering column bracket.
13. Install the cable end to the steering column ball stud.
14. Install the retainer securing the cable to the steering column.
15. Position the carpet and insulation around the driver's area.
16. Install the driver's seat.
17. Install the instrument panel knee bolster.
18. Test the transmission for proper shift operation.
19. If all of the gear positions cannot be achieved, adjust the cable.
Automatic Transmission Range Selector Cable Bracket Replacement
Automatic Transmission Range Selector Cable Bracket Replacement
Removal Procedure
1. Apply the park brake.
2. Shift the transmission into neutral.
3. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
4. Remove the retainer that secures the cable to the bracket.
5. Depress the tangs and remove the cable from the bracket.
