Yukon/Denali 2WD V8-4.8L VIN V (2005)
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the rear axle fill plug.
3. Remove the rear axle drain plug.
4. Drain the lubricant into a suitable container.
5. Inspect the drain plug for excessive metal particle accumulation. This accumulation is symptomatic of extreme wear.
6. Clean the drain plug.
Installation Procedure
1. Notice: Refer to Fastener Notice in Service Precautions.
Install the rear axle drain plug.
^
Tighten the rear axle drain plug to 27 Nm (20 ft. lbs.).
2. Fill the rear axle. Use the proper fluid.
3. Install the rear axle fill plug.
^
Tighten the rear axle fill plug to 21 Nm (15 ft. lbs.).
