Yukon/Denali 2WD V8-4.8L VIN V (2005)
10. Remove the ring gear from the differential case. Drive the gear off with a brass drift if necessary.
Notice: Refer to Ring Gear Removal Notice in Service Precautions.
Installation Procedure
1. Determine the pinion position shim thickness and the pinion preload shim thickness for the drive pinion gear.
2. Install the ring gear to the differential case. Align the holes in the differential case to the bolts holes in the ring gear.
Important: The mating surface of the ring gear and the differential case must be clean and free of burrs before installing the ring gear.
3. Install the new ring gear bolts. Hand start each bolt to ensure that the ring gear is properly installed to the differential case.
Important: The ring gear bolts have right-hand threads.
4. Tighten the new ring gear bolts. Tighten the ring gear bolts alternately and in stages, gradually pulling the ring gear onto the differential case.
^
Tighten the new ring gear bolts to 178 Nm (131 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the differential assembly.
6. Fill the axle with lubricant. Use the proper fluid.
7. Lower the vehicle.
