Yukon/Denali 2WD V8-4.8L VIN V (2005)
5. If replacing both the left side seal and bearing, perform the following steps:
5.1. Remove the differential carrier assembly. Refer to Differential Carrier Assembly Replacement.
5.2. Place the differential carrier assembly into a vise.
Clamp only on the mounting flange of the differential carrier assembly case.
5.3. Remove the inner axle shaft using a hammer and a brass drift.
5.4. Install the J 29369-1 , 8.25 inch axle, or the J 29369-2 , 9.25 inch axle (1), behind the inner axle shaft seal or the inner axle shaft bearing as
necessary.
5.5. Install the J 2619-01 (2) to the J 29369-1 or the J 29369-2.
5.6. Remove the inner axle shaft seal and/or the inner axle shaft bearing using the J 2619-01.
Installation Procedure
