Yukon/Denali 2WD V8-4.8L VIN V (2005)
Front Door Window Motor: Service and Repair
Window Regulator Motor Replacement - Front Door
Removal Procedure
1. Raise the window.
If the window motor is inoperable, remove the glass window to gain access to the window motor retaining screws.
2. Remove the door trim panel.
3. Remove the water deflector.
4. Remove the door speaker.
5. Support the glass.
6. Disconnect the wiring harness from the window regulator motor.
7. Remove the 3 bolts (1) from the window motor located on the front side of the motor.
Important: Do not allow the cable gear to come out of the housing. Failure will result in the cable coming off the spool.
8. Separate the motor from the cable housing by wiggling the window motor.
Observe the orientation of the window motor.
9. Remove the motor from the window regulator assembly.
Installation Procedure
1. Install the window motor to the cable housing by wiggling it into place.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the 3 bolts (1) to the window regulator motor.
Tighten the bolts to 5 N.m (44 lb in).
3. Install the glass window, if removed.
4. Connect the wiring harness to the window regulator motor.
5. Remove the window support.
6. Connect the wire connector to the switch to inspect the operation of the window.
After inspection disconnect the wire harness and continue the installation.
7. Install the speaker.
8. Install the water deflector.
9. Install the door trim panel.
