Yukon/Denali 2WD V8-4.8L VIN V (2005)
Windshield Washer Reservoir: Service and Repair
WASHER PUMP/RESERVOIR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the battery and battery tray from the vehicle.
2. Remove the inner wheel housing from the vehicle.
3. Disconnect the electrical connector from the washer pump.
4. Disconnect the electrical connector from the washer solvent level sensor.
5. Disconnect the washer hose from the washer pump.
6. Remove the upper bolt from the washer solvent container.
7. Remove the lower bolts from the washer solvent container.
8. Remove the washer solvent container from the vehicle.
INSTALLATION PROCEDURE
1. Install the washer solvent container into the vehicle.
2. Install the lower bolts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolts to 9 N.m (80 lb in).
