Yukon/Denali 2WD V8-5.3L VIN Z Flex Fuel (2005)
Seat Heater Switch: Procedures
Heated and Cooled Seat Switch Replacement (Front-Platinum Models)
HEATED AND COOLED SEAT SWITCH REPLACEMENT (FRONT-PLATINUM MODELS)
REMOVAL PROCEDURE
1. Remove the floor console bezel.
2. Remove the 4 retaining screws (1).
3. Remove the switch assembly from the console bezel.
INSTALLATION PROCEDURE
1. Install the switch assembly to the bezel.
2. Install the 4 retaining screws (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 2 N.m (18 lb in).
3. Install the floor console bezel.
Heated and Cooled Seat Switch Replacement (Rear-Platinum Models)
HEATED AND COOLED SEAT SWITCH REPLACEMENT (REAR-PLATINUM MODELS)
REMOVAL PROCEDURE