Yukon/Denali 2WD V8-5.3L VIN Z Flex Fuel (2005)
Power Steering Line/Hose: Service and Repair
Power Steering Gear Inlet Pipe/Hose Replacement
With Hydroboost
Power Steering Gear Inlet Pipe/Hose Replacement (With Hydroboost)
Removal Procedure
Notice: Refer to Power Steering Hose Disconnected Notice in Cautions and Notices.
1. Install a drain pan under the vehicle.
2. Remove the power steering gear inlet hose (1) from the brake booster.
3. Remove the power steering gear inlet hose from the power steering gear.
4. Remove the power steering gear inlet hose from the vehicle.
Installation Procedure
Notice: Refer to Installing Hoses Without Twists or Bends Notice in Cautions and Notices.
1. Route the hose in the same position the hose occupied prior to removal.
2. Install the power steering gear inlet hose (1) to the brake booster (2). Hand tighten only.
Notice: Refer to fastener Notice in Cautions and Notices.
3. Install the power steering gear inlet hose to the power steering gear
^
Tighten both power steering gear inlet hose fittings to 28 Nm (20 ft. lbs.).
4. Remove the drain pan from under the vehicle.
5. Bleed the power steering system.
Without Hydroboost