Yukon/Denali 2WD V8-5.3L VIN Z Flex Fuel (2005)
11. If only the left side seal was removed, perform the following step. Install the inner axle shaft into the differential case side gear using a soft-faced
mallet until the retaining ring on the inner axle shaft is fully seated within the groove in the differential case side gear.
Pull back on the inner axle shaft to ensure that the inner axle shaft is properly retained in the differential case side gear.
12. If only the left side seal was removed, perform the following step. Install the wheel drive shaft to the inner axle shaft.
Notice: Refer to Fastener Notice in the Preface section.
13. If only the left side seal was removed, perform the following step. Install the wheel drive shaft to the inner axle shaft bolts.
Tighten
Tighten the wheel drive shaft to inner axle shaft bolts to 79 Nm (58 lb ft).
14. Fill the differential carrier assembly. Use the correct fluid. Refer to Front Axle Lubricant Replacement.
15. Lower the vehicle.
