Yukon/Denali 2WD V8-6.0L VIN U (2004)
6. Install the park brake cable to the equalizer bar.
7. Remove the safety stands.
8. Lower the vehicle.
(Without RPO Nys)
Park Brake Cable Replacement - Right Rear (without RPO NYS)
Removal Procedure
1. Release the park brake.
2. Raise and support the vehicle. Refer to Vehicle Lifting..
3. Relieve the tension from the park brake cable by pulling down on the cable in front of the equalizer and removing the cable from the equalizer bar.
4. Disconnect the cable from the equalizer.
5. Remove the bolt from the rear axle clip.
6. Remove the cable from the differential clip.
