Yukon/Denali 2WD V8-6.0L VIN U (2004)
Seat Belt Retractor: Service and Repair
No. 2 Rear (60/40 Split - 50/50 Split)
SEAT BELT RETRACTOR REPLACEMENT - NO. 2 REAR
CAUTION: To avoid personal injury to the occupants of the vehicle, observe the following precautions:
-
More than one supplier's seat belts are used, therefore, install ONLY the seat belt components specified in the GM parts catalog.
-
To verify that the correct seat belt components were installed, insert the seat belt latch in the seat belt buckle. The latch must be fully
seated and be retained in the buckle until purposely released.
Removal Procedure
1. Remove the seat from the vehicle.
2. In order to release the seat back, manually rotate the center latch. Rotate the latch until the seat back releases the seat back.
3. Remove the latch cover (1) from the seat
.
4. Remove the seat belt anchor bolt (1) from the cushion frame.
5. Remove the head rests.
6. Remove the seat back cover and pad.
7. Remove the seat back frame.
8. Remove the seatbelt retractor bolt cover (1).
9. Remove the retractor mounting bolts (2).
