Yukon/Denali 2WD V8-6.0L VIN U (2004)
Removal Procedure
1. Raise and support the vehicle.
2. Remove the wheel and tire assembly from the vehicle.
3. Disconnect the sensor harness connector from the vehicle harness connector.
4. Remove the bolt from the electronic suspension control (ESC) sensor link bracket.
5. Spread the bracket open until the bracket can be removed from the upper control arm.
6. Remove the bolts from the frame.
7. Remove the position sensor from the vehicle.
Installation Procedure
1. Install the position sensor on the vehicle.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the bolts to the frame.
^
Tighten the bolts to 12 Nm (106 inch lbs.).
