Yukon/Denali 2WD V8-6.0L VIN U (2004)
7. Center the splice clip (2) over the stripped wires (1) and hold the clip in place.
-
Ensure that the wires extend beyond the clip in each direction.
-
Ensure that no insulation is caught under the clip.
8. Center the crimp tool over the splice clip and wires.
9. Apply steady pressure until the crimp tool closes.Ensure that no strands of wire are cut.
10. Crimp the splice on each end (2).
11. Apply 60/40 rosin core solder to the opening in the back of the clip. Follow the manufacturer's instructions for the solder equipment.
