Yukon/Denali 4WD V8-4.8L VIN V (2005)
INSTALLATION PROCEDURE
1. Paint the new rear object sensor. Refer to Basecoat/Clearcoat Paint Systems in Paint/Coatings.
IMPORTANT: Do not refinish previously painted sensors. Excess paint build up will cause the sensor to be inoperative.
2. Check to make sure the paint does not exceed 6 mils. Use a paint thickness gauge suitable for non-ferrous metals. Refer to Paint Gages in
Paint/Coatings.
3. Paint the sensor bezel to match the color of the bumper fascia.
4. Align the keyhole (2) with the key (1) and press the sensor bezel into the fascia.
5. Install the housing to the bezel through the back side of the fascia. The housing snaps into the cutouts on the bezel.
6. Install the spring (1) to the housing (2) until fully seated.Ensure the sensor is held to the bumper fascia firmly.
IMPORTANT: The spring keys must be on the top and bottom of the housing.
