Yukon/Denali 4WD V8-4.8L VIN V (2005)
1. Install the handle to the vehicle.
2. If the lock cylinder is replaced, apply lubricant GM P/N 12345120, Canadian P/N 726548, or equivalent, to the inside of the lock case and of the
cylinder keyway.
3. Install the door-lock cylinder to the outside handle housing.
In order to code a new lock cylinder, refer to Key and Lock Cylinder Coding.
4. Install the lock cylinder clip to the lock cylinder rod.
5. Install the handle rod to the handle assembly clip.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the outside handle mounting nuts.
Tighten the nuts to 9 N.m (80 lb in).
7. Install the rubber cover.
8. Install the water deflector.
9. Install the trim panel.
