Yukon/Denali 4WD V8-4.8L VIN V (2005)
1. Repair any damage done to the pillar during the drilling or the removal.
2. Position the service hinge within the scribe marks on the pillar.
3. Center punch each bolt location on the pillar according to the service hinge (Fig. 4-63).
4. Drill a 3 mm (1/8 in) pilot hole at each punch location (Fig. 4-64).
5. Drill a 13 mm (1/2 in) hole at the pilot locations (Fig. 4-65).
6. Clean and prepare all bare metal surfaces.
IMPORTANT: Prior to refinishing, refer to the publication GM4901M-D-2000 "GM Approved Refinish Materials" for recommended products.
Do not combine paint systems. Refer to paint manufacturer's recommendations.
