Yukon/Denali 4WD V8-4.8L VIN V (2005)
Trim Panel: Service and Repair
Garnish Molding Replacement
Garnish Molding Replacement - Center Pillar
GARNISH MOLDING REPLACEMENT - CENTER PILLAR
REMOVAL PROCEDURE
1. Remove the door sill plates.
2. Remove the pillar moldings by holding the moldings firmly while pulling out.
INSTALLATION PROCEDURE
1. Install the pillar moldings by pushing until the molding locks into place.
2. Install the door sill trim plates.
Garnish Molding Replacement - Rear Corner
GARNISH MOLDING REPLACEMENT - REAR CORNER
REMOVAL PROCEDURE
1. Remove the rear upper garnish molding.
2. Pull down on the upper corners of the garnish molding in order to disengage the retaining clips.
3. Pull in order to disengage the remaining retaining clips.
4. Remove the rear corner garnish molding from the vehicle.
5. Inspect the rear corner garnish molding for broken or missing retaining clips. Replace the retaining clips as needed.
INSTALLATION PROCEDURE