Yukon/Denali 4WD V8-4.8L VIN V (2005)
Sunroof / Moonroof Wiring Harness: Service and Repair
SUNROOF WIRING HARNESS REPLACEMENT
REMOVAL PROCEDURE
1. Remove the headliner.
2. Disconnect the wire harness connectors (5) and (6).
IMPORTANT: Observe the routing of the wire harness. Failure to route the wire the same will result in the wire harness being pinched during
sunroof operation.
3. Remove the wire from the sunroof module.
INSTALLATION PROCEDURE
1. Connect the wire connector (6).
2. Secure the wire harness along the out board flange (7) and (2).
IMPORTANT: Do not route the wire harness on the top or the bottom of the flange as it will get pinched during sunroof operation.
3. Secure clip (1) and clip (3) to sunroof module flange.
4. Loop the wire harness around cable drive (4).
5. Connect the wire harness (5) to the sunroof motor.
6. Install the headliner.
7. Inspect the operation of the sunroof.
