Yukon/Denali 4WD V8-4.8L VIN V (2005)
6. Remove the lower I/P reinforcement brace bolt (1) from the electronic adjustable pedal (EAP) bracket.
7. Remove the I/P reinforcement brace.
8. Disconnect the electrical connectors from the following components:
-
The adjustable pedals motor assembly
-
The memory sensor connector, if equipped
-
The pedal position sensor
-
The accelerator wiring harness connector
9. Remove the pushrod retaining clip (3) from the brake pedal pin (1).
10. Remove the brake pedal pushrod (2) and the stop lamp switch (4) from the brake pedal.
