Yukon/Denali 4WD V8-4.8L VIN V (2005)
Brake Hose/Line: Service and Repair
Brake Hose Replacement - Rear
(Caliper)
Brake Hose Replacement - Rear (Caliper)
Removal Procedure
Caution: Refer to Brake Fluid Irritant in Service Precautions.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components in Service Precautions.
1. Raise and support the vehicle. Refer to Vehicle Lifting..
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
3. Clean all dirt and foreign material from the brake hose end and brake pipe fitting.
Important: Install a rubber cap or plug to the exposed brake pipe fitting end in order to prevent brake fluid loss and contamination.
4. Use a backup wrench on the brake hose fitting end (1), disconnect the brake pipe fitting end (2) from the brake hose (1) then cap or plug the brake
pipe fitting end.
5. Remove the brake hose retaining clip (3) from the brake hose mounting bracket.
6. Remove the brake hose (1) from the mounting bracket.
7. Remove the brake hose to caliper bolt from the brake caliper.
8. Remove and discard the 2 copper brake hose gaskets. These gaskets may be stuck to the brake caliper housing or the brake hose end.
Installation Procedure
