Yukon/Denali 4WD V8-4.8L VIN V (2005)
1. Important: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
Install the EBCM (2) onto BPMV (3).
2. Notice: Refer to Fastener Notice in Service Precautions.
Important: Do not reuse the old mounting bolts. Always install new EBCM bolts with the new BPMV.
Install the EBCM bolts (1).
^
Tighten the bolts to 5 Nm (39 inch lbs.) in an X-pattern.
3. Install the BPMV (3) to EHCU bracket (5).
4. Install the BPMV to bracket retaining bolts (4).
^
Tighten the bolts to 9 Nm (7 ft. lbs.).
5. Install the EHCU to the vehicle frame (5).
6. Install the EHCU bracket bolts.
^
Tighten the EHCU bracket bolts (4) to 25 Nm (18 ft. lbs.).
7. Connect the electrical connectors to the EBCM (1).
8. Important: The brake pipes are held in place by a plastic bracket mounted to the frame. Make sure that the brake pipes stay in the correct place
for proper reassembly.
Install the brake pipes to the BPMV (2).
^
Tighten the brake pipe fittings to 25 Nm (18 ft. lbs.).
9. Bleed the brake system using the ABS Automated Bleed Procedure (W/JL4).
