Yukon/Denali 4WD V8-4.8L VIN V (2005)
10. If vehicle is a 1500 series with the first design cable, perform the following:
1. Install the park brake cable through the frame bracket and guides.
2. Install the left rear park brake cable (3) from the equalizer bar.
11. Remove the safety stands.
12. Lower the vehicle.
13. Adjust the park brake cable. Refer to Park Brake Adjustment.
(With RPO Nys)
Park Brake Cable Replacement - Left Rear (with RPO NYS)
Removal Procedure
1. Release the park brake.
2. Raise and support the vehicle. Refer to Vehicle Lifting..
3. Remove the park brake cable from the equalizer by pulling down on the intermediate cable and release the cable from the equalizer bar.
4. Remove the cable from the mounting bracket by depressing the locking tabs.
