Yukon/Denali 4WD V8-4.8L VIN V (2005)
5. Install the park brake cable taking care to correctly route the cable though the guides and the body mounts.
6. Install the park brake cable to the equalizer bar.
7. Remove the safety stands.
8. Lower the vehicle.
(Without RPO Nys)
Park Brake Cable Replacement - Right Rear (without RPO NYS)
Removal Procedure
1. Ensure that the park brake is released.
2. Raise and support the vehicle.
3. If vehicle is a 1500 series with the first design cable, perform the following:
1. Relieve tension on the park brake cables by pulling down on the front park brake cable (1) just in front of the equalizer.
2. Remove the left rear park brake cable (3) from the equalizer bar.
