Yukon/Denali 4WD V8-4.8L VIN V (2005)
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 1.6 N.m (14 lb in).
3. Connect the electrical connection at the mode actuator (10).
4. Install the center console duct.
5. Install the screws to the center console duct.
Tighten the screws to 1.6 N.m (14 lb in).
6. Install the center console.
7. Install the floor air outlet duct extension (1) to the floor air duct (2).
Mode Actuator (Without RPO Code D07)
MODE ACTUATOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the floor air outlet duct extension (1) from the floor duct (2).
2. Remove the body control module.
