Yukon/Denali 4WD V8-4.8L VIN V (2005)
Glove Box Lamp Switch: Service and Repair
INSTRUMENT PANEL (I/P) COMPARTMENT LAMP SWITCH REPLACEMENT
REMOVAL PROCEDURE
1. Lower the instrument panel storage compartment door by pressing in the tab.
2. With one hand holding the plunger of the switch, use a small screw driver to push in the tabs on each side while pulling outwards.
3. Pull the switch assembly from the I/P.
4. Disconnect the electrical connector.
5. Remove the bulb (1).
INSTALLATION PROCEDURE
1. Install the bulb (1) into the socket.
2. Connect the electrical connector.
3. Install the switch until the tabs (1) click in place.
4. Close the compartment door.
