Yukon/Denali 4WD V8-4.8L VIN V (2005)
Power Steering Line/Hose: Service and Repair
Power Brake Booster Hose Replacement
Inlet
Power Brake Booster Inlet Hose Replacement
Removal Procedure
Notice: Refer to Power Steering Hose Disconnected Notice in Cautions and Notices
1. Install a drain pan under the vehicle.
2. Remove the brake booster inlet hose (1) from the brake boosters).
3. Remove the brake booster inlet hose from the power steering pump.
4. Remove the brake booster inlet hose from the vehicle.
Installation Procedure
Notice: Refer to Installing Hoses Without Twists or Bends Notice in Cautions and Notices.
1. Route the hose in the same position the hose occupied prior to removal.
2. Install the brake booster inlet hose (1) to the brake booster (2). Hand tighten only.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Install the brake booster inlet hose to the power steering pump.
^
Tighten the brake booster inlet hose fittings to 28 Nm (20 ft. lbs.).
4. Remove the drain pan from under the vehicle.
5. Bleed the power steering system.
