Yukon/Denali 4WD V8-48L VIN V (2005) Side Air Bag Component Locations
Side Air Bag: Service and Repair
INFLATABLE RESTRAINT SIDE IMPACT MODULE REPLACEMENT - FRONT
REMOVAL PROCEDURE
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 7 and to SIR Disabling and Enabling Zone 9.
CAUTION:
-
Refer to SIR Inflator Module Handling and Storage Caution in Service Precautions.
-
Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary:
-
The seat cushion frame
-
The seat recliner, if equipped
-
The seat adjuster
-
The seat back frame
Failure to do so may cause future personal injury.
2. Remove the front seat.
3. Remove the seat back cover.
4. Remove the retaining bolts (3) that attach the inflatable restraint side impact module (1) to the seat frame.
5. Remove the side impact module retainer.
6. Remove the wiring harness retaining clips from the seat frame (3).
IMPORTANT: Note the routing of the inflatable restraint side impact module wiring harness and the retaining clips within the seat frame. You must
route the wiring harness (2) in the exact same way as the factory to eliminate the possibility of any cutting or chafing of the wiring harness.
7. Remove the wiring harness (2) from the seat frame (3).
8. Remove the side impact module (1) from the seat frame (3).
9. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required
retention period. Refer to Inflator Module Handling and Scrapping.
INSTALLATION PROCEDURE
1. Install the module wiring harness (2) to the seat frame (3) while guiding the wiring harness through the appropriate spots on the seat frame.
2. Install the wiring harness retaining clips to the seat frame.
