Yukon/Denali 4WD V8-4.8L VIN V (2005)
5. Slide the intermediate shaft down, out of the steering column connection.
6. Remove the accelerator pedal position sensor.
7. Slide the upper intermediate shaft towards the instrument panel, out of the lower intermediate shaft, and remove the shaft from the vehicle.
Installation Procedure
1. Install the lower end of the upper intermediate shaft through the bulkhead, into the lower shaft.
Important: If you are installing the same shaft, align the marks and the relationship of the bolt and clamp made during the removal procedure.
2. Install the upper end of the upper intermediate shaft (2) to the steering column.
3. Install the bolt and nut (1) at the connection of the upper intermediate shaft to the steering column.
^
Tighten the nut to 62 Nm (46 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the accelerator pedal position sensor.
5. Install the bolt and nut at the connection of the upper intermediate shaft to the lower intermediate shaft.
Tighten the nut to 47 Nm (35 ft. lbs.).
6. Remove the J 42640 from the steering column lower access hole.
