Yukon/Denali 4WD V8-4.8L VIN V (2005)
7.
From inside the vehicle remove the upper bolt from the upper intermediate steering shaft (1) to the steering column connection.
8.
Remove the upper intermediate steering shaft assembly.
1.
From inside the vehicle slide the shaft down and off the steering column.
2.
From inside the vehicle slide the upper intermediate shaft through the dash boot seal and remove the shaft from the vehicle.
9.
Replace the upper intermediate shaft.
10.
Install the upper intermediate steering shaft through the dash boot seal and slide the lower end into the steering gear coupling shaft.
11.
Raise the upper end of the intermediate steering shaft and install into the steering column shaft.
12.
Install the upper bolt and nut.
Tighten
Tighten the bolt to 47 N.m (35 lb ft).
13.
Install the lower bolt and nut.
Tighten
Tighten the bolt to 50 N.m (37 lb ft).
14.
For vehicles equipped with adjustable foot pedals perform the following steps:
1.
Reposition the accelerator pedals into position on the bulkhead.
2.
Install the two retaining nuts.
Tighten
Tighten the nuts to 20 N.m (15 lb ft).
3.
Reposition the carpet into place.
Parts Information
Warranty Information
For vehicles repaired under warranty use, the table.
