Yukon/Denali 4WD V8-4.8L VIN V (2005)
Stabilizer Link: Technical Service Bulletins
Suspension - Revised Stabilizer Link Service/Torque
Bulletin No.: 05-03-08-006
Date: April 12, 2005
SERVICE MANUAL UPDATE
Subject:
Revised Stabilizer Shaft Link Replacement Procedure and Fastener Tightening Specifications
Models:
1999-2005 Chevrolet and GMC Full Size Pickup and Utility Models
2003-2005 HUMMER H2
This bulletin is being issued to revise the Stabilizer Shaft Link Replacement Procedure and Fastener Tightening Specifications in the Front Suspension
sub-section of the Service Manual. Please replace the current information in the Service Manual with the following information.
The following information has been updated within SI. If you are using a paper version of this Service Manual, please make a reference to this bulletin
on the affected page.
The following revision affects both the Fastener Tightening Specifications and the Stabilizer Shaft Link Replacement procedure.
Pickup and Utility Models : Stabilizer Shaft Link Nuts - 10 Nm (89 lb in)
Continue tightening the nut until 2 to 4 threads protrude above the nut.
H2 : Stabilizer Shaft Link Nuts - 14 Nm (124 lb in)
Continue tightening the nut until 2 to 4 threads protrude above the nut.
The following Notice has been added to the Stabilizer Shaft Link Replacement procedure.
Note:
To avoid stabilizer shaft damage due to loss of clamp load, the threads of the link bolt must protrude 2 to 4 threads above the nut after the specified
torque is achieved.
Disclaimer
