Yukon/Denali 4WD V8-4.8L VIN V (2005)
Important: Install the adjustment bolt the same amount of turns that were required to remove the bolt during removal.
8. Install the adjustment bolt (3) and the adjuster nut (4).
9. Install the adjustment bolt (3) and the adjuster nut (4), for vehicles with MN8, MT1 AND MW3.
10. Remove the J 36202 releasing the tension on the torsion bar until the load is taken up by the adjustment bolt.
11. Remove the safety stands.
12. Lower the vehicle.
13. Measure the Z height.
14. Turn the adjustment bolt (2) clockwise to increase the Z height and counterclockwise to decrease the Z height.
