Yukon/Denali 4WD V8-4.8L VIN V (2005)
Shifter A/T: Service and Repair
Shift Lever Replacement (With Tow/Haul Switch)
Shift Lever Replacement (With Tow/Haul Switch)
Removal Procedure
1. Remove the 2 TORX head screws from the lower column trim cover.
2. Remove the lower column trim cover.
3. Roll back the seal on the shift lever (1) until the TORX® head shift lever screw (2) is exposed.
4. Remove the TORX head shift lever screw (2).
5. Remove the knee bolster.
6. Remove the nuts (1) from the knee bolster deflector bracket.
7. Notice: During removal of the steering column the wire harness retaining clip must be removed and reinstalled after installing the steering column
or damage may occur to the wire harness.
Remove the wiring harness retaining pin (4) from the instrument panel.
8. Remove the wire straps and open the harness insulation to gain access to the electrical wiring.
9. Remove the wiring from the electrical connector.
10. Remove the shift lever.
Installation Procedure
