Yukon/Denali 4WD V8-4.8L VIN V (2005)
43.
Install the right inner axle shaft housing assembly to the differential carrier assembly.
44.
Install the inner axle shaft housing bolts.
Tighten
Tighten the inner axle shaft housing bolts to 40 N.m (30 lb ft).
45.
Install the inner axle shaft housing washers and nuts to the bracket.
Tighten
Tighten the inner axle shaft housing nuts to 100 N.m (75 lb ft).
46.
Connect the wheel drive shaft inboard flange to the inner axle shaft.
47.
Install the wheel drive shaft inboard flange to the inner axle shaft bolts.
Tighten
Tighten the wheel drive shaft inboard flange to the inner axle shaft bolts to 79 N.m (58 lb ft).
48.
Connect the wire harness to the inner axle shaft housing and differential carrier.
49.
Connect the electrical connector to the front axle actuator.
50.
Fill the differential carrier assembly with axle lubricant. Use the proper fluid. Refer to Lubricant Replacement - Front Drive Axle in the Front Axle
sub-section of the Service Manual.
51.
Install the front engine protection shield. Refer to Engine Protection Shield Replacement in the Frame and Underbody sub-section of the service
manual.
52.
Lower the vehicle.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table.