Yukon/Denali 4WD V8-4.8L VIN V (2005)
Important: Tighten the seal cover clamp (1) as tight as possible without deforming the retaining clip. Clamps that are not tight enough allow the
cover to slide upon the joint. This causes shortened service life.
10. Use J 41187 in order to tighten the outboard cover clamp (1).
11. Rotate J 41187 toward the clip in order to bend the band onto the clip.
12. Pull the tool's cutting handle in order to cut off the excess band.
13. Pound the band flat between the latch tabs. Peen the latch tabs over in order to lock the band into position.
