Yukon/Denali 4WD V8-4.8L VIN V (2005)
8. Insert a flat-tipped screwdriver or small pry bar into the space between the lip of the outer race of the seal and the transfer case.
9. Remove the remaining part of the output shaft seal from the transfer case.
Installation Procedure
1. Install the J 43484 (2) to the J 8092 (1).
2. Install a NEW seal onto J 43484.
3. Using J 43484 (2), and J 8092 (1), install the seal.
4. Install the front propeller shaft.
5. Check the fluid level. Add fluid, if necessary.
6. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement.
7. Lower the vehicle.
Transfer Case Output Shaft Seal Replacement- Rear
Transfer Case Output Shaft Seal Replacement- Rear
^
Tools Required
-
J 45756 Output Shaft Seal Installer
Removal Procedure
