Yukon/Denali 4WD V8-4.8L VIN V (2005)
Wiper Motor: Service and Repair
Wiper Motor Replacement - Rear
WIPER MOTOR REPLACEMENT - REAR
REMOVAL PROCEDURE
1. Remove the wiper arm.
2. Remove the nut and spacer from the wiper motor shaft.
3. Remove the interior trim panel.
4. Disconnect the wiper motor electrical connector.
5. Remove the two screws.
6. Remove the wiper motor.
INSTALLATION PROCEDURE
1. Install the wiper motor.
2. Install the two screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 19 N.m (14 lb ft).
3. Connect the wiper motor electrical connector.
4. Install the interior trim panel.
5. Install the spacer and the nut on the wiper motor drive shaft.
Tighten the nut to 8 N.m (71 lb in).
6. Install the wiper arm.
