Yukon/Denali 4WD V8-5.3L VIN T (2004)
4. Remove the top 2 retaining screws.
5. Move the end panel rearwards to gain access to the electrical connectors.
6. Remove the end panel from the console.
7. Remove the rear seat heater switch, if equipped.
8. Remove the rear seat audio controls, if equipped.
9. Remove the power outlets from the end panel, if equipped.
Installation Procedure
1. Install the power outlets to the end panel, if equipped.
2. Install the rear seat audio control, if equipped.
3. Install the rear seat heater switch, if equipped.
4. Connect all electrical connectors.
5. Install the end panel to the console.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the 2 top retaining screws.
Tighten the screws to 1.6 N.m (14 lb in).
