Yukon/Denali 4WD V8-5.3L VIN T (2004)
Seat Belt Retractor: Service and Repair
No. 2 Rear (Bench)
SEAT BELT RETRACTOR REPLACEMENT - NO. 2 REAR
REMOVAL PROCEDURE
CAUTION: To avoid personal injury to the occupants of the vehicle, observe the following precautions:
-
More than one supplier's seat belts are used, therefore, install ONLY the seat belt components specified in the GM parts catalog.
-
To verify that the correct seat belt components were installed, insert the seat belt latch in the seat belt buckle. The latch must be fully
seated and be retained in the buckle until purposely released.
1. Remove the seat back cover and pad.
2. Remove the seat belt retractor bolt (1) from the seat frame.
3. Remove the retractor.
INSTALLATION PROCEDURE
1. Install the retractor.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the seat belt retractor bolt (1) to the seat frame.
Tighten the bolt to 53 N.m (39 lb ft).
3. Install the seat back cover and pad.
