Yukon/Denali 4WD V8-53L VIN T (2004) - Front Drive Axles Seal and Gasket Repair
13. Install the top half of the J-36652-01 for the 1500 models (except 1500 HD) or J36652-98 for the 1500 HD, 2500, 3500 and HUMMER H2
models.
14. Align the swage ring (2) and the swage ring clamp.
15. Insert the bolts.
^
Hand tighten the bolts until the bolts are snug.
16. Align the following during this procedure:
^
The tripot boot (3)
^
The tripot housing (1)
^
The swage ring (2)
^
Tighten each bolt 180 degrees at a time. Alternate between the bolts until both sides of the top half of the tool touch the bottom half.
^
Loosen the bolts and remove the halfshaft assembly from the tool.
17. Inspect the inboard stroke position.
^
Use measurement A for the 1500 models (except 1500 HD).
^
Use measurement B for the 1500 HD, 2500, 3500, and Hummer H2 models.
18. Remove the convolute retainer tool from the boot.
Wheel Drive Shaft Outer Joint and Seal Replacement
Wheel Drive Shaft Outer Joint and Seal Replacement
^
Tools Required
-
J 8059 Snap Ring Pliers
-
J 35910 Seal Clamp Tool
-
J 36652 Drive Axle Clamp Swage Tool
Disassembly Procedure
